32
RayChart 620 and 630
Setting Up &
Using On-screen
Routes
D3827-2
✣
CURSOR
50°36.68 N
009°47.60 E
COG SOG
208°M1.4$
DEPTH IN FEET
100$
To Cursor
BRG
RNG
218°M 415.2$
003WPT
50°43.06 N
000°59.39 W
PLACE WPT DELETE WPT
ADD WPT EDIT
10. When you have entered all your waypoints, press CLEAR to return to the
initial screen.
Your route is displayed on the screen, but is not active.
➤ To add waypoints to a route using an external device such as the NavPlotter
100, use the MAKE /EDIT option as described above. You can then add
waypoints using either the cursor and the PLACE WPT key, or using the external
device. When an external waypoint is received, the cursor is positioned on it
and the chart is centered.
Editing an Existing Route On-Screen
You can edit the current route, even if it is active. You do this using the same
screen you used for entering a new on-screen route.
➤ To add waypoints to the end of an existing route:
1. Press the ROUTE soft key to display the Route menu and the current route
selection.
2. Use the trackpad, or press the ROUTE soft key, to highlight the MAKE/EDIT
option, and press ENTER.
The cursor is connected to the last-placed waypoint with a dotted line,
ready to add further waypoints to the route in the same way as for a new
route.
You can now add, delete or insert waypoints, although you cannot delete a
waypoint if you are tracking towards it.
To Next Page
Loading...
