34
RayChart 620 and 630
Setting Up &
Using On-screen
Routes
D3828-2
SAVE & FOLLOW SAVE AND EXIT
CURSOR
50°36.68 N
009°47.60 E
COG SOG
208°M 1.4$
DEPTH IN FEET
100$
To Cursor
BRG
RNG
218°M 415.2$
SCROLL
DIGITS
SELECT
CLEAR
CANCEL
ENTER
ACCEPT
SELECTION
ROUTE SAVE
LEG LAT/LON
01 43°58.95 N 010°06.64 E
02 43°59.62 N 010°05.51 E
03 44°00.40 N 010°03.93 E
WPT NAME
004WPT
003WPT
002WPT
SYM SOURCE
CURSOR
CURSOR
CURSOR
ROUTE NAME: ROUTE ØØ
The route name is shown at the top of the route details. For each waypoint
you placed, the following information is given:
Leg The leg number
Position The position of the waypoint at the end of this leg.
The position is given as either latitude and longitude or TDs,
depending on your setup selection.
WPT Name The waypoint name. The default name is in the format
xxxWPT, where xxx is the waypoint number.
Waypoints are listed in the Waypoint List in alphanumeric
order by name (see Chapter 5). If you plan to use the
Waypoint List, you may wish to name related waypoints so
that they are grouped together in the list.
Sym The waypoint symbol. The default is a circle, but you can
change it to any of the mark/event symbols (see page 42).
Source The source of the position information. For routes placed
on-screen, this is always the cursor. If you edit the position,
the source is updated to “EDIT”.
You can change the route name or the waypoint positions, names or
symbols.
2. Use the left or right sides of trackpad to move the cursor to the number,
letter or symbol you wish to change. You can hold the trackpad down to
move quickly, or press ENTER to skip to the start of the next field.
3. Use the top or bottom of the trackpad to increase or decrease the number, or
change the letter or symbol.
To Next Page
Loading...
