Chapter 6: Customizing the Chartplotter 81
➤ To set up a customized window:
1. Press MENU to display the main menus.
2. Use the trackpad or the SCREEN soft key to highlight the WINDOWS option
from the SCREEN menu, and press ENTER.
The Customize On Screen Data Windows screen is displayed, showing the
last-used window selection. An example screen is shown below.
D3811_2
CDI
BDI
COMPASS
RUDDER
STEER CDI
STEER BDI
NAVDATA
SPEED
AVERAGE SPEED
MAXIMUM SPEED
DEPTH
MIN DEPTH
MAX DEPTH
SEATALK
RESTORE WIN
CLEAR WINDOW
DEL LAST ITEM
EDIT REVIEW
CUSTOM WIN 01
CUSTOM WIN 02
CUSTOM WIN 03
CUSTOM WIN 04
CURSOR
50°36.68 N
009°47.60 E
COG SOG
208°M 1.4$
DEPTH IN FEET
100$
To Cursor
BRG
RNG
218°M 415.2$
CUSTOM WIN 01
EMPTY WIN
3. If the custom window you wish to set up or change is not already displayed,
use the REVIEW soft key to display the required window.
Now you are ready to start specifying the data that will be displayed. The
NAVDATA and SEATALK menus list all the data that is available for selection:
further options can be seen by scrolling down the menus using the trackpad
or soft keys.
4. Highlight one of the data options in either the NAVDATA or SEATALK menu,
and press ENTER.
The data appears in the window at the top of the screen. Most of the
SeaTalk items take up one line, but some (such as the FULL WPT selection)
take up 2 lines. Some items, such as CDI, fill the entire window – the
display will not change if there is insufficient space in the window.
5. If you make a mistake or change your mind, you can delete the last item
using the DEL LAST ITEM option from the EDIT menu.
Alternatively, you can clear all the items in the window using the CLEAR
WINDOW option. RESTORE WIN will restore a cleared window that has been
saved.
6. Repeat step 4 until you have selected all the data items you require.
Customizing the
Screen Display
To Next Page
Loading...
