REI OSCOR Blue User Manual

MULTI-PURPOSE PROBE
95
To measure signals with the IR detector:
1. On the OSCOR unit, make sure that the “IR (Infrared Light)” input is selected.
2. The IR detector on the MPP is located on the end with the Photo Detector label. Point this end
toward any suspected IR source.
Notes
- Infrared signals must be line of sight between the MPP and either the infrared transmitter or a
reflection from the transmitter. For best results in locating transmitters, point the infrared
receiver in all directions in a variety of angles (e.g., pointed up or pointed down) while sweeping
a room.
- The 100 MHz Baseband Upconvert option mixes the signal with a 100 MHz signal for analyzing
baseband (see page 97).

REI OSCOR Blue Specifications

General

Brand	REI
Model	OSCOR Blue
Category	Measuring Instruments
Language	English