SET-UP & BASIC OPERATION
24
Several other tasks can be performed from the Storage Manager:
• Refresh Devices – When the storage manager is first open, it will automatically detect all storage
devices connected to the OSCOR. However, while the storage manager is open, if devices are
connected or disconnected, it may be necessary to press Refresh Devices to refresh the tree list.
• Delete Partition – Select a partition in the tree list and press Delete Partition to delete the
partition. WARNING Any existing data on the partition will be lost! Make sure to transfer any
data you wish to keep to another device before performing the Delete Partition function.
Resetting to Factory Defaults
If you have changed any of the settings on your OSCOR unit, such as trace colors or preset spans, it is
possible to reset the unit to the default conditions shipped from the factory.
To reset to factory defaults:
1. From the Main Menu, select System or press F6.
2. From the Systems Sub-Menu, select the Defaults icon.
3. The system will ask for confirmation to restore system settings to their defaults. Select Yes or
press F5 to restore the default settings. Select No or press F6 to cancel.
The following stored system settings will be restored to their default settings:
- Trace Colors
- Custom Spans
- Color Gradient Settings
- Visibility state of graph adornments, such as the Trace Legend and Sweep Counts
Note: If you have created several custom spans that you wish to save, you may want to export these
custom spans (see page 26) before resetting to factory defaults, so that you can easily restore them
afterwards.
Setting up the Tuner
To Next Page
Loading...
