OPERATION
75
• New–Opens a blank signal list to which signals can be manually added in Analyze Mode.
• Open List–Opens previously saved signal lists.
• Close List – Closes a signal list that is open. If the signal list has not been saved up to that point,
you will be asked whether or not to save the list.
• Save – Saves the currently open signal list
• Save As – Allows the saving of the currently open signal list to a new filename or a new location
• Merge – Merges multiple signal lists (see page 52).
• Auto Analyze - For each signal in a signal list, Auto Analyze will automatically fine tune the main
carrier frequency and bandwidth measurements. For any analog signals, Auto Analyze will also
determine whether or not the demodulated audio correlates with room audio. (See page 56.)
The following functions are available in the Signals|Signals Sub-Menu:
• Add – Adds a signal to the signal list at the cursor’s current position. If a signal list is already
open, the signal will be added to this list. If no signal list is open, a new list will be created with
this signal added.
• Remove – Removes the currently highlighted signal from displayed signal list.
• Edit – Add additional information, such as location, threat, and comments, to the currently
selected signal in the signal list. Also, the frequency, amplitude and bandwidth values of the
currently selected signal can be tweaked with the Edit icon.
• Previous – The cursor will move to the signal in the Signal List with the next lowest frequency.
• Next – The cursor will move to the signal in the Signal List with the next highest frequency.
• Closest – If the cursor is not already positioned on a signal in the currently open signal list, it will
move to the closest one.
The following functions are available in the Signals|Options Sub-Menu:
• Show List – Toggles the display of Signals tab
• Markers – Toggles the display of markers in the spectrum graph for any currently opened signal
list
To Next Page
Loading...
