System Service Mode
D037/D038/D040/D041 9-192 SM Appendix
001
The program selects a paper size system from the following alternatives: the
AB system (0), the LT system (1), and the AF system (2).
5150 [By-Pass Length Setting]
*CTL
[0: OFF/ 1: ON]
001
Determines whether the transfer sheet from the by-pass tray is used or not.
Normally the paper length for sub scanning paper from the by-pass tray is
limited to 600 mm, but this can be extended with this SP to 1260 mm.
5162 [App. Switch Method]
*CTL
[0: Soft Key Set/ 1: Hard Key Set]
001 This program specifies the switch that selects an application program.
[Fax Printing Mode at Optional]
5167
Enables or disables the automatic print out without an accounting device. This
SP is used when the receiving fax is accounted by an external accounting
device.
001
Fax Printing Mode at
Optional Counter Off
*CTL
[0 or 1 / 0 / - ]
0: Automatic printing
1: No automatic printing
[CE Login]
5169
If you will change the printer bit switches, you must ‘log in’ to service mode with
this SP before you go into the printer SP mode.
001 CE Login *CTL
[0 or 1 / 0 / - ]
0: Disabled
1: Enabled
[By-pass Size Error Detection]
5179
Turns on or off the by-pass tray size error message.
To Next Page
Loading...
Need help?
General
