Troubleshooting
304
9
Memory Full 1.TX 2.Cancel Memory has reached capacity
while scanning originals
when trying to send a fax in
Memory Transmission mode.
Press {1} to send only the pag-
es that have been scanned in
memory, or press {2} to can-
cel.
Misinstall Print Cartridge The print cartridge has not
been installed or has not been
installed correctly.
Reinstall the print cartridge.
See p.307 “Replacing the Print
Cartridge”.
Near End Print Cartridge The print cartridge is almost
empty.
Prepare a new print cartridge.
Near Memory Full Memory has almost reached
capacity during sort copy.
If several originals are still to
be scanned, it is recommend-
ed to start printing now, and
copy the remaining originals
separately. If originals are be-
ing scanned from the ADF, re-
move any remaining pages
from the ADF.
Net Communication Error
Press Clear Key
Connection with the server
was lost while sending or re-
ceiving data.
Contact the network adminis-
trator.
Network Is Not Ready Press
Clear Key
A scanned file could not be
sent because the machine has
not received IP address infor-
mation from the DHCP server
completely.
Wait until the machine re-
ceives the IP address informa-
tion completely, and then try
the operation again.
No Profile Exist No Quick Dial entry is associ-
ated with the One Touch but-
ton you pressed.
• Press a different One
Touch button.
• Assign a registered desti-
nation to the One Touch
button. See p.134 “Regis-
tering Scan Destinations”.
Outer Jam Paper has been jammed in the
machine.
Remove the jammed paper.
See p.272 “Removing Printing
Jams”.
Please Reboot System An error occurred and the ma-
chine cannot continue to oper-
ate.
Turn off the power, and then
turn it back on.
Message Causes Solutions
To Next Page
Loading...
