2
USB Quick Install
If you have connected this machine to your computer via USB cable, select this
method to auto install the necessary printer and TWAIN drivers from the CD-
ROM.
Important
❒ The procedure in this section is an example based on Windows XP. The actual
procedure might vary depending on the operating system you are using.
❒ To install the drivers, you must have an account that has Manage Printers
permission. Log on as an Administrators or Power Users group member to
acquire this permission.
❒ Be sure to disconnect the USB cable from the machine or turn the machine off
before beginning the installation.
Use this procedure to install the drivers using USB Quick Install.
A Close all applications except this manual.
B On the [
Printer/Scanner Drivers and Utilities
] dialog box, click [
USB Quick Install
].
The software license agreement appears.
C After reading the agreement, click [
I accept the agreement.
], and then click
[
Next
].
A dialog box prompting you to confirm that connection with the machine has
not been made appears.
D Make sure the machine is turned off and not connected to the computer,
and then click [
Next
].
The [
Printer Auto-Detecting
] dialog box appears.
E Connect the machine and the computer using a USB cable, and then turn
the machine's power switch to on.
The auto-detecting starts.
To cancel the auto-detecting click [
Stop Auto-detecting
].
F When the message informing you that the installation was successfully
completed appears, click [
Finish
].
Note
❒ In this procedure, PCL 6 was the only PCL driver installed. If you need to
install the PCL 5c driver, install it separately, and be sure to configure it us-
ing the same settings as the PCL 6 driver that is already installed.
To Next Page
Loading...
