LAN Type
Select Ethernet or Wireless LAN. This menu appears only when the optional Wireless LAN
interface unit is installed.
Default: [Ethernet]
• Ethernet
• Wireless LAN
Parallel Interface
Specify parallel interface settings. This menu appears when the IEEE 1284 interface board is installed.
Parallel Timing
Specify the parallel interface timing.
Default: [ACK outside]
• ACK inside
• ACK outside
• STB down
Parallel Comm. Speed
Specify whether or not to use DMA transfer for receiving data.
Default: [High Speed]
• High Speed
• Standard
Selection Signal Status
Specify the selection signal level of the parallel interface.
Default: [High]
• High
• Low
Input Prime
You usually do not need to change this setting.
Default: [Inactive]
• Active
• Inactive
Bidirectional Comm.
Specify whether to enable or disable bi-directional communication.
Default: [On]
• On
5. Making Printer Settings Using the Control Panel
144
To Next Page
Loading...
