• Off
Wireless LAN
Configure settings for Wireless LAN. This menu appears only when the optional Wireless LAN interface
unit is installed.
Communication Mode
Specify the transmission mode for Wireless LAN.
Default: [Infrastructure Mode]
• 802.11 Ad-hoc Mode
• Infrastructure Mode
SSID Setting
Specify an SSID in infrastructure mode and Ad-hoc Mode.
Select [?] to enter [/] for the SSID. Also, [\] appears when printing the configuration page, read
it as [/].
Characters used are ASCII 0x20-0x7e (32 bytes).
An SSID is set automatically to the nearest access point if no SSID has been set.
If no SSID has been set for Ad-hoc Mode, an SSID is set automatically and the same SSID is
used for Ad-hoc Mode and infrastructure mode.
If blank is specified in SSID for Ad-hoc Mode, "ASSID" appears.
An SSID can also be set using Web Image Monitor. For details, see Web Image Monitor Help.
Default: blank (SSID)
• SSID
Ad-hoc Channel
Specify the channel to use when [802.11 Ad-hoc Mode] has been selected. Set the channel
that matches the type of wireless LAN being used. The channel in use might differ depending on
the country.
The following channels are available:
(mainly Europe and Asia)
• IEEE 802.11a/b/g Wireless LAN
Frequency range:
2412 - 2472 MHz (1 - 13 channels)
5180 - 5240 MHz (36, 40, 44, and 48 channels)
In some countries, only the following channels are available:
• IEEE 802.11b/g Wireless LAN
Frequency range:
Host Interface Menu
145
To Next Page
Loading...
Need help?
General
