2412 - 2462 MHz (1 - 11 channels)
Default: [11]
(mainly North America)
• IEEE 802.11a/b/g Wireless LAN
Frequency range:
2412 - 2462 MHz (1 - 11 channels)
5180 - 5240 MHz (36, 40, 44, and 48 channels)
Default: [11]
Security Method
Select whether to enable encryption and specify the security type when the encryption is enabled.
WPA appears only when the optional Wireless LAN interface unit is installed.
Default: [Off]
• Off
• WEP
Press [Details], and then enter the WEP key using hexadecimal and ASCII characters.
• WPA
Press [Details], and then select the Encryption and Authentication Methods.
Select one of the following Encryption Methods:
TKIP, CCMP(AES)
Select one of the following Authentication Methods:
WPA-PSK, WPA, WPA2-PSK, WPA2
Wireless LAN Signal
You can check the signal strength when using Wireless LAN.
Restore Defaults
Reset the Wireless LAN to default.
USB Settings
Configure the communication parameters for computer-to-printer connection via USB.
USB Speed
Default: [Auto Select]
• Auto Select
• Full Speed
Fixed USB Port
Default: [Off]
5. Making Printer Settings Using the Control Panel
146
To Next Page
Loading...
Need help?
General
