Differences between VT2130 and VT2300
Some of the VT2300’S features were not offered on
the VT2130, but were
available on the SS950. Since this update is being
issued to technicians
who are trained on the SS950, these features will not be explained
here in
detail. More information on all of the differences listed below can be found
in the VT2130 addendum to the SS950 Service Manual.
The VT2300 has an Automatic Document Feeder (ADF) like the SS950.
The maximum print area is 9.8” x 13.7”
The Vl_2300 offers 3 step enlargement. The process used is simply the
reverse of the procedure used for reduction in other models. (For details
see page 2-10 of the VT2130 addendum to the SS950 Service Manual.)
The Skip Paper Feed Switch has been added. (Addendum page 1-7, #27)
There have been changes made to the Operations Panel. (Addendum
page 1-8)
Three
sensors and a circuit board have been added to detect paper size.
(Addendum pages 1-13, 1-18 and 1-19)
A Drum Master Detect Sensor has been added, (Addendum pages 1-15
and 5-71)
A Drum Lock Solenoid has been added. (Addendum pages 1-16 and 5-70)
The Original Pressure Solenoid, Transport Roller Pressure and Master Eject
sensor are now adjustable. (Addendum pages 5-4, 5-5 and 5-34)
Please review the enclosed material and the W2130 update package care-
fully. Pay particular attention to the sections of theVT2130 addendum
which refer to the VT2300. As stated on the update cover page, these sec-
tions were not relevant at the time that the package was issued. It is impor-
tant that you now take the time to become familiar with this information, in
order to be able to properly service the VT2300.
To Next Page
Loading...
