Copying
28
2
Copies are delivered face down.
Note
❒ Always log off when you have finished using the machine to prevent un-
authorized users from using the machine.
❒ To stop the machine during a multi-copy run, press the {Clear/Stop} key.
❒ To cancel all copy jobs and return the machine to the default condition,
press the {Clear Modes} key.
❒ To clear entered values, press the {Clear/Stop} key or [Cancel] on the screen.
❒ To confirm settings, press the [Check Modes].
Interrupt Copy
Use this function if you want to interrupt a long copy job to make urgently need-
ed copies.
Important
❒ You cannot use the Interrupt Copy function when fax originals are being
scanned or the scanner function is being used.
A Press the {Interrupt} key.
B The machine stops scanning. Remove the originals that were being copied.
C Place the originals you want to copy.
D Press the {Start} key.
The machine starts making copies.
E When copying is complete, remove the originals and copies.
F Press the {Interrupt} key again.
The interrupt key indicator goes off.
G Replace the originals that you were copying, and then press the {Start} key.
Following message “
Reset n originals.”, replace the originals that you
were copying.
AQI033S
To Next Page