2. Select [Scan to Email] on the scanner screen.
3. Place the original on the scanner.
See "Placing an Original to Scan", User Guide (Full Version).
4. Press [Send Settings] on the scanner screen.
5. Press [Sender] and specify the sender.
• When a logged in user is operating the machine, the logged in user becomes the sender.
• When [On] is specified in [System Settings]
[Send (Email/Folder)] [Email] [Auto
Specify Sender Name], you can send an e-mail even when the sender is not specified. The
administrator's e-mail address that is registered on the machine is used as the sender.
• Specify the sender to receive an opening confirmation.
6. Select the [Reception Notice] check box to receive an opening confirmation of the e-mail
from the destination.
7. Specify the destination on the scanner screen.
• To enter the e-mail address manually, select the destination from the destination history, or
search for the destination in the address book, press , and specify the destination.
6. Scan
140
To Next Page
Loading...
