page 210 "Specifying Paper Type and Thickness Settings"
• Check the paper setting before printing. If the paper differs from the paper setting, a mismatch error
will occur when you print.
• Straighten curled or warped paper before loading.
• When loading paper on a tray which has a few sheets of paper, multiple sheets of paper may be
fed at once from the tray. Take out all sheets, fan the sheets, and then load them again.
• You may hear the sound of rubbing paper. This is not a malfunction.
• Do not stack paper over the limit mark.
Fanning the Paper
• If you load coated paper, label paper, or thick paper of 150.1–300.0 g/m
2
(55.1 lb. Cover–
165.0 lb. Index), it is important that you fan the sheets thoroughly. Misfeeds may occur if paper is
not fanned thoroughly.
1. Loosen the stack by riffling the sheets.
2. Holding its shorter ends, flex the stack back and forth to create space between the sheets.
Repeat this several times.
9. Adding Paper and Toner
176
To Next Page
Loading...
