page 208 "Specifying the Paper Size That Is Not Automatically Detected"
page 209 "Specifying a Custom Size Paper Using the Control Panel"
• Replace the paper supports after use.
Loading Paper into the Interposer
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
• When using the Z-fold function, the paper in the interposer must be of the same size as the prints
after they have been folded. If the paper in the interposer is larger than the Z-folded sheets, a
misfeed might occur.
• Do not use paper that has already been printed onto by this machine.
1. Load paper orderly.
Do not stack paper over the limit mark.
2. Adjust the side fences to the paper size.
Loading Paper into the Paper Tray
205
To Next Page
Loading...
