1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Square the paper and load it print side down.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
4. Specify the paper type and thickness.
page 210 "Specifying Paper Type and Thickness Settings"
Loading Paper into Trays 2 and 3
Each paper tray is loaded in the same way.
In the following example procedure, paper is loaded into Tray 2.
• Check that the paper edges are aligned at the right side.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
9. Adding Paper and Toner
180
To Next Page
Loading...
