• Load tab stock so that the side with the tab faces the tab sheet holder.
• Pressing the release lever, adjust the end fence position so that the tab sheet holder fits against the
tab stock.
Specify the paper type and thickness before you start printing.
page 210 "Specifying Paper Type and Thickness Settings"
When loading paper of a size that is not automatically detected, specify the paper size.
page 208 "Specifying the Paper Size That Is Not Automatically Detected"
page 209 "Specifying a Custom Size Paper Using the Control Panel"
Loading Paper into the Bypass Tray
Use the bypass tray to use adhesive labels, translucent paper, and paper that cannot be loaded in the
paper trays.
The maximum number of sheets you can load at the same time depends on paper type.
page 213 "Recommended Paper Sizes and Types"
• Do not stack paper over the limit mark. If you load paper over the limit mark, the print image may
be slanted or the paper may be jammed.
9. Adding Paper and Toner
184
To Next Page
Loading...
