Basic Procedure for Performing Send to Folder
1. Press [Scanner] on the Home screen.
2. Select [To Folder] on the scanner screen.
3. Place the original on the scanner.
See "Placing an Original to Scan", User Guide (Full Version).
4. Press [Send Settings] and configure the scan settings according to the purpose of the
scanned data.
page 156 "Scanning an Original with Suitable Quality and Density"
page 159 "Specifying the File Type or File Name When Scanning a Document"
5. Press , select [Search Address Book] or [Specify by Reg. No.] and then specify the
shared folder that is registered in the address book.
• To enter the information manually, press , and select [Manual Entry]. Select SMB as the
protocol and enter the required information.
• To specify the destination again, press .
6. Press [Start].
6. Scan
154
To Next Page
Loading...
