3. Loosen the screws holding the side fences in position.
4. Holding the labeled parts of the side fences, slide the fences outward.
5. While pressing the release button of the end fence, slide the end fence outward.
6. Load paper into the paper tray with print side up.
Load a stack of paper about 5–10 mm (0.2–0.4 inches) high, using the symbol at the bottom of
the side fence as a guide.
Make sure that the paper rest on top of the supporting plates on both sides.
Set the paper flush against the left fence and align the paper edges.
9. Adding Paper and Toner
196
To Next Page
Loading...
