9. Load additional sheets, if necessary.
Do not stack paper over the limit mark.
10. While pressing the release button of the end fence, align the end fence gently against the
paper you loaded.
Make sure that there is no space between the paper and end fence.
11. Carefully slide the paper tray fully in.
If you push the paper tray too forcefully when you put it back in place, the position of the paper
might change and print accuracy becomes lower.
12. Specify the paper type and thickness.
page 210 "Specifying Paper Type and Thickness Settings"
9. Adding Paper and Toner
198
To Next Page
Loading...
