1. Open the front cover of the wide LCT, remove the screws from the postcard side fences,
and then take them out.
2. Close the front cover.
3. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
4. Fit the indentation on the bottom of the postcard side fence with the limit mark into the
head of the screw on the bottom of the inner side fence.
5. Fit the hole on the top of the postcard side fence into the projection on the top of the side
fence.
Set the other postcard side fence to the front side fence in the same way.
Loading Paper into the Paper Tray
201
To Next Page
Loading...
