Align the side fences gently against the paper you loaded, if necessary.
1. Paper extenders
3. When loading paper of a size that is not automatically detected, specify the paper size.
page 208 "Specifying the Paper Size That Is Not Automatically Detected"
page 209 "Specifying a Custom Size Paper Using the Control Panel"
• Load paper with its printed side up (the front side).
• Load paper in the twin interposer in the same orientation as paper in the paper tray.
• The staple position or punch hole position will be on the left side of the paper, when you are facing
the machine.
• To load the paper in the twin interposer, align the orientation of originals in the ADF as shown
below.
Twin interposer ADF
Loading Paper into the Paper Tray
207
To Next Page
Loading...
