Icon Condition Solution and reference
Paper is jammed. See the animated illustration displayed on the
control panel, and remove the jammed
paper.
See "When Paper or an Original is Jammed",
User Guide (Full Version).
An original has jammed. See the animated illustration displayed on the
control panel, and remove the jammed
original.
See "When Paper or an Original is Jammed",
User Guide (Full Version).
Paper has run out. Load paper into the paper tray.
page 175 "Loading Paper into the Paper
Tray"
Toner is almost depleted, or has run out. Prepare a replacement toner. Replace the
toner when it runs out.
• If appears when there is a lot of toner,
pull out the print cartridge by following
the toner replacement procedure that is
displayed on the screen, and then set it
back again.
page 237 "Replacing the Toner"
The waste toner bottle is full, or almost full. Prepare a replacement waste toner bottle.
Replace the bottle when it becomes full.
Staples are nearly depleted, or have run
out.
Prepare a cartridge for replacement, and
load it when the staples run out.
page 241 "Replenishing the Staples"
The hole punch receptacle is full. Empty the receptacle.
See "When the Hole Punch Receptacle is
Full", User Guide (Full Version).
A cover is open. Check that all covers of the machine and
options are closed.
10. Troubleshooting
248
To Next Page
Loading...
