• If the Auto Specify Sender Name function is enabled, the sender is automatically specified
and you can omit the procedure for specifying a sender.
7. Press [Start].
To cancel transmission after scanning the original, press [Stop] and operate in [Job Status]
[Transmission Standby File].
See "Confirming and Handling a Document in the Fax Queue", User Guide (Full Version).
• If the telephone line you are connected to requires time to connect to the public line after you dial
the external number, enter a [Pause] after entering the number to specify the time to wait before
dialing the number. The machine pauses for about two seconds for each single [Pause] entered.
• To use tone-dialing in a pulse-dialing environment, press [Tone]. A tone signal is generated for
every number you enter afterward.
• You can perform Immediate transmission only when the total number of destinations specified for
all documents exceeds the maximum value.
• The communication that has been initiated first is displayed on the screen when performing three
simultaneous communications.
Basic Procedure for Transmitting Faxes
87
To Next Page
Loading...
