T
echnical
B
ulletin PAGE: 3/5
Reissued:23-Oct-13
Model:
Aries-P1.5/C1.5
Date:
7-May-13
No.:
RM077092a
NOTE: See photos and diagrams below for a reference on the appropriate
amount of pressure that should be applied when polishing the belt.
4. After polishing the fusing belt, put back the fusing unit.
5. Print out sample copies to check if vertical lines appear or not.
NOTE
Make sure to polish front and rear (operator and non-operator) sides of the
fusing belt, because belt scratches are generated by both front and rear edges of
paper.
To Next Page
Loading...
