Technical Bulletin PAGE: 14/75
Reissued:21-Apr-14
1-3. Click “Measure” to get the measurements.
1-4. In the printer driver setting, select the Color tab.
1-5. Select standard or expert, and the paper type from the following 3 default options:
Plain, Gloss, or Matte.
NOTE: The above steps 1-1 ~ 1-3 (calibration in Command Workstation) and 1-4 ~ 1-5
(output profile selection in printer driver) must be performed as a set as calibration
performed in Command Workstation is reflected only to the corresponding paper
type selected in the printer driver. To confirm the output profiles associated with
the calibrations performed, go to Command Workstation > Device Center >
Resource > Profile > Output Profiles.
1-6. Run a test print and check with your customer if the results are accepted. If accepted,
complete the procedure. However, if unaccepted, do the next “Screening Setting”
procedure.
To Next Page
Loading...
