Technical Bulletin PAGE: 35/44
Model: Aries-P1.5/C1.5 Date: 17-Feb-11 No.: RM077018
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
170. Check or clear obstacles around the motor drive
mechanism.
171. Check the harness connection.
172. Replace the upper tray junction gate HP sensor.
173. Replace the upper tray junction gate motor.
174. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Staple Junction Gate Motor Error: 3K Finisher B830
The staple tray junction gate HP sensor did not detect the gate at
the home position within 200 ms after two attempts.
-or-
The HP sensor twice detected the gate at the home position for
more than 200 ms after it was supposed to open.
The 1st failure causes a jam error, and the 2nd failure causes this
SC code.
Junction gate did not arrive at the home position within the
specified time
Junction gate did not leave the home position within the
specified time
735 B
175. Check or clear obstacles around the motor drive.
176. Check the harness connection.
177. Replace the staple tray junction gate HP sensor.
178. Replace the staple junction gate motor.
179. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Pre-Stack Junction Gate Motor Error: 3K Finisher B830
The pre-stack junction gate HP sensor did not detect the gate at
the home position for within 200 ms after two attempts.
-or-
The HP sensor twice detected the gate at the home position for
more than 200 ms after it was supposed to open.
The 1st failure causes a jam error, and the 2nd failure causes this
SC code.
736 B
Junction gate did not arrive at the home position within the
specified time
Junction gate did not leave the home position within the
specified time
To Next Page
Loading...
