Technical Bulletin PAGE: 36/44
Model: Aries-P1.5/C1.5 Date: 17-Feb-11 No.: RM077018
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
180. Check or clear obstacles around the motor drive
mechanism.
181. Check the harness connection.
182. Replace the pre-stack junction gate HP sensor.
183. Replace the pre-stack junction gate motor.
184. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Pre-Stack Transport Motor Error: 3K Finisher B830
The pre-stack transport motor is not operating.
Motor harness loose, broken, defective
Motor is blocked by an obstruction
Motor defective
Finisher main control board defective
737 B
185. Check or clear obstacles around the motor drive
mechanism.
186. Check the harness connection.
187. Replace the pre-stack transport motor.
188. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
Pre-Stack Junction Gate Release Motor Error: 3K Finisher B830
The pre-stack junction gate release HP sensor did not detect the
gate at the home position within 200 ms after two attempts.
-or-
The HP sensor twice detected the gate at the home position for
more than 200 ms after it was supposed to open.
The 1st failure causes a jam error, and the 2nd failure causes this
SC code.
Junction gate did not arrive at the home position within the
specified time.
Junction gate did not leave the home position within the
specified time.
738 B
189. Check or clear obstacles around the motor drive
mechanism.
190. Check the harness connection.
191. Replace the pre-stack junction gate release HP sensor.
192. Replace the pre-stack junction gate release motor.
193. Replace the finisher main board.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
740 B Finisher corner stapler motor error: 3K Finisher B830
To Next Page
Loading...
