Error Messages
M0C3/M0C4/M0C5/M0C6/M0C7 6-14 SM
Message Causes Solutions
Comb.: 2 on 1 / 4 on 1 tray does not contain a valid
size of paper, which are A4,
Letter, or Legal size.
paper in the [Select Paper]
settings.
• Specify A4, Letter, A5, 5.5×8.5, or
A6 size paper for the tray
selected for printing copies.
Cannot copy.
Set original to ADF.
Combined copying could not
be performed because the
originals were not placed in
the ADF.
• Use the ADF, even when copying
a single sheet.
• If you need to use the exposure
glass, select [Off] or [Manual
2Sd Scan Mode] in
[Duplex/Combine] under [Copier
Features], and then try again.
Check Paper Size The paper size set for the
document differs from the
size of the paper in the
indicated tray.
• When using the touch panel
models
Press [Form Feed] to begin
printing, or press [Job Reset] to
cancel the job.
• When using the Four-line LCD
models
Press the [OK] key to begin
printing, or press the [Back] key
to cancel the job.
Check Paper Type The paper type set for the
document differs from the
type of the paper in the
indicated tray.
Connection Failed The line could not be
connected correctly.
• Confirm that the telephone line is
properly connected to the
machine.
• Disconnect the telephone line
from the machine, and connect
a standard telephone in its
place. Confirm that you can
make calls using the telephone.
If you cannot make calls this
way, contact your telephone
company.
Cover open A cover is open. Close the cover completely.
Dial Failed The fax could not be sent.
• Confirm that the fax number you
To Next Page
Loading...
Need help?
General
Weight and Dimensions
