Page 34
Remote User Operation by Telephone
You can remotely operate the system from a touch-tone phone by initiating a telephone
call to the system and then interacting with voice menus that guide you through the
operations. You can also receive voice notifications of events to your telephone, and from
the menu options you can then perform system operations as well.
Accessing the System by Telephone
Remotely accessing the system involves initiating a call to the system and entering your
remote access code and the user code you usually enter at the LCD/Panda keypad.
To remotely access the system:
1. From a remote touch-tone telephone, dial the number at the premises where Agility 4 is
installed (for the telephone connected to the Agility 4 main panel).
2. If your system is connected to a landline telephone and an answering machine is in use
at the premises, let it ring once then hang up, wait 20 seconds, and then call again.
3. If an answering machine is not in use at the premises, wait until the system picks up.
After the system picks up a short tone is heard.
NOTE: When the system picks up, if there are multiple phones on the same line, all are
effectively disconnected and cannot be used (depending on installer wiring).
4. Enter your 2-digit remote access code within 5 seconds (default code = 00); the
following is announced: "Hello, Please Enter Your User Code, Followed By #".
5. Enter your user code followed by # (default user code=1234).
6. After your code is accepted a system status message is announced, and you are now in
the Operations menu (see next page).
To Next Page
Loading...
