Risco Agility 4 - Adding and Deleting Proximity Tags; Adding a Proximity Tag; Deleting a Proximity tag

Page 44
Adding and Deleting Proximity Tags
At the LCD/Panda keypad you can use a proximity tag instead of entering your code – for
performing Setting/Unsetting or activating/deactivating functions.
The following Proximity tag operations can be performed:
 Adding a new proximity tag
 Deleting a proximity tag by the user’s index number
 Deleting a proximity tag by the user’s tag
Adding a Proximity Tag
The Grand Master can assign a tag to any user in the system. Each proximity tag can be
assigned to only one user.
To add a proximity tag:
1. Press / and enter your code to enter the User Menu.
2. Use / to scroll to Codes/Tags, and then press / .
3. Scroll to Proximity Tags, and then press
/ .
4. Scroll to New/Change, and then press / .
5. Scroll to select the user index number (to designate a tag to), and then press
/ ; “Approach Tag” displays.
6. Within 10 seconds, hold the tag 1—2 cm (.4—.8 in) from the LCD keypad buttons / at
the right–hand side of the Panda Keypad display; the keypad then reads and saves the
tag information. A long confirmation beep sounds, and a confirmation message is then
displayed. If a proximity tag’s information has already been saved in the system’s
memory, 3 error beeps will sound and a reject message will appear.
Deleting a Proximity tag
Deleting proximity tags can be performed as follows:
 By user index number: Use this option to delete a tag for which the user is known
 By tag: Use this option to delete a tag for which the user is not known