Risco Agility 4 - SMS Operation; SMS Confirmation Reply; Table of SMS Commands

Page 37
SMS Operation
The following table describes user SMS commands for remote system operations.
NOTE: For SMS operation, the GSM/GPRS module must be installed in your system.
SMS Confirmation Reply
An SMS sender can receive a confirmation (or fail) reply from the system upon request, by
adding the letters RP at the end of any SMS command (see table below of SMS commands):
Table of SMS Commands
Operation SMS Command Example
Full Set code + S 1234S
Part Set code + P 1234P
Unset code + US 1234US
Partition Full Set code + S + partition number 1234S1
Partition Part Set
code + P + partition number 1234P1
Partition Unset code + US + partition number 1234US1
Omit Zone code + OM + zone number 1234OM05
Un-Omit Zone code + UNOM + zone number 1234UNOM05
Activate Output code + POON + UO number 1234POON1
Deactivate Output code + POOFF + UO number 1234POOFF1
Change FM Number
code + FMPHONE+ FM serial
number + NEW +new phone number
1234FMPHONE3
NEW0529692345
Get system status code + ST 1234ST
View last alarm code + AL 1234AL
Get SIM credit level (for
prepaid cards)
code + CR 1234CR
NOTES:
 SMS commands can be sent from any mobile phone or from an SMS website.
 Command words are not case sensitive.
 A separator between command words is not required although it is accepted.