Page 33
System Operation by Remote Control
Changing the Remote Control Code
Each remote control can be defined by your installer to have a unique 4-digit code, which
is used to perform operations in High Security mode. To change the remote control code, it
is mandatory to perform the following procedure in close proximity to the control panel.
To change the remote control code:
1. Press
and
4
?
simultaneously for 2 seconds.
2. Enter the current 4 digit code.
3. Press
, then enter a new 4 digit code.
4. Press
; the panel will send a confirmation message, the remote control will sound
a long beep, and the green LED on the remote control will turn on. If no confirmation
sound is heard the old code still remains. In that case, repeat the procedure again.
Clearing a Remote Control Command
When sending a command from a remote control, if you want to clear (cancel) the
command before it is executed, press
twice.
To Next Page
Loading...
