Risco Agility 4 - Editing User Parameters (Label, Partition, Authority)

Page 42
6. Scroll to select the index number (to designate to a system user), and then press
/ .
NOTE: Index number 00 is reserved for the Grand Master, while the other index
numbers (01 through 31) are for all other system users.
7. Enter the new code.
8. Re-enter the new code; the system beeps and “Accepted” displays. If not re-entered
correctly, the system sounds 3 beeps.
9. To edit parameters for the user such as Label (name), Partition, and Authority (level),
do the following:
a. Repeat steps 1—3 in this procedure, then scroll to Parameters and press
/ .
b. Scroll to the index number (of the user you want to define), and then press
/ ; “Label” appears.
c. Scroll between Label, Partition, and Authority, and press / to select:
 For Label, edit by entering text over the existing description, then press
/ .
NOTE: Press each button repeatedly without pausing to toggle between all of its
possible characters. Use / to scroll between spaces, and
to delete a character.
 For Partition, scroll between each partition (1, 2, and 3), and then for each,
press / to toggle to either Y (to create partition) or leave it blank (to
not partition), and then press
/ .
 For Authority, scroll between the authority level options (Set only, Duress,
Door Omit, User, or Cleaner), and then press
/ to select one of the
options to assign to the user.