Riverstone Networks RS 3000/3100/3200 Switch Router Getting Started Guide v
VCCI COMPLIANCE STATEMENT
This is a Class A product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio
disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.
BSMI (TAIWAN BUREAU OF STANDARDS, METROLOGY AND INSPECTION,
MINISTRY OF ECONOMIC AFFAIR)WARNING:
Warning: This is a Class A product. In a domestic environment this product may cause radio interference..
SAFETY INFORMATION: CLASS 1 LASER TRANSCEIVERS
This product may use Class 1 laser transceivers. Read the following safety information before
installing or operating this product.
The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This
control loop eliminates the need for maintenance checks or adjustments. The output is factory set and does
not allow any user adjustment. Class 1 laser transceivers comply with the following safety standards:
• 21 CFR 1040.10 and 1040.11, U.S. Department of Health and Human Services (FDA)
• IEC Publication 825 (International Electrotechnical Commission)
• CENELEC EN 60825 (European Committee for Electrotechnical Standardization)
When operating within their performance limitations, laser transceiver output meets the Class 1 accessible
emission limit of all three standards. Class 1 levels of laser radiation are not considered hazardous.
INFORMACIÓN SOBRE LA SEGURIDAD: TRANSMISOR/RECEPTOR LASER DE
CLASE 1
Este producto puede utilizar transmisores/receptores láser de Clase 1. Lea la siguiente información de
seguridad antes de instalar u operar este producto.
Los transmisores/receptores láser de Clase 1 utilizan un circuito óptico de control de retroalimentación
para mantenerse dentro de los límites operativos de la Clase 1. Debido al uso del circuito de control, no es
necesario llevar a cabo ajustes o revisiones de mantenimiento. La potencia ha sido configurada en la
To Next Page
Loading...
Need help?
General
