Robopac ROBOTAPE 50 CFA - 2 Safety Information; General Safety Precautions; Employer Obligations; Safety Warnings for Handling and Installation

ROBOTAPE 50 CFA
2. SAFETY INFORMATION
2.1. GENERAL SAFETY PRECAUTIONS
― Carefully read the “Directions for use”, paying particular attention to the “Residual risks”.
― Pay attention to the safety warnings.
― Use the machine only for the use for which it is designed.
― Sometimes, accidents can be caused by a "careless" use of the machine by the operator.
― Pay maximum attention.
― Preserve the readability of the information signs and observe the indications given.
― Do not tamper with the safety devices and protections.
―
T
he
p
ersonnel authorised to carr
y
out an
y
o
p
eration on the machine has to be ade
q
uatel
y
trained.
2.1.1.EMPLOYER OBLIGATIONS
― The operator must possess the required training and meet the suitable conditions for carrying out the
activities in safety conditions.
― The employer must inform the operator on the INCORRECT USES predictable and on the persistent
Residual risks.
― The operator must be capable of reading and understanding the user manual and must easily identify
the safety signs.
―
T
he em
p
lo
y
er must ade
q
uatel
y
document the trainin
g
obtained b
y
the o
p
erators.
2.2. SAFETY WARNINGS FOR HANDLING AND INSTALLATION
― The personnel authorised to handle the machine (loading and unloading) must possess particular
expertise in the field of intervention.
― Carry out handling (loading and discharge) according to the information delivered together with the
product.
― During handling use one or two assistants, if required. This operation may generate unpredictable risks.
― In order to minimise the risks related to assistants' involvement, you must inform them priorily on the
type of work and the behaviour to be used.
― The machine must be handled with the aid of specific means (crane, forklift etc.) by qualified personnel
capable of observing the safety requirements.
― When using the lifting means, insert and/or fasten the devices (hooks, forks etc.) ONLY into the points
provided on the package and/or the machine.
―
T
rans
p
ort the machine suitable means of ade
q
uate ca
p
acit
y
.
― The minimum and maximum temperature (during transport and/or storage) must fall within the range
allowed in order to
p
revent dama
g
in
g
the electrical com
p
onents.
― Install the machine ONLY in s
p
aces free of ex
p
losion and /or fire risks.
― Avoid the s
p
aces ex
p
osed to atmos
p
heric and corrosive a
g
ents.
― Assess, prior to installation, if it is necessary to draw up a "safety plan" in order to protect the safety of
the
p
ersonnel involved.
― Ensure suitable safety conditions for carrying out works at height in areas difficult to reach or however
dan
g
erous.
― Install the machine according to the minimum perimeter indicated by the manufacturer and the
surroundin
g
activities.
― Should the machine interface directly/indirectly with other machines or production lines, draw up the
installation desi
g
n of the machine.
― The design must include all the operating conditions in order to comply with the standards in force on
safet
y
at work
p
lace.
― Check that the installation space is properly ventilated in order to avoid air concentration unhealthy for
the o
p
erators.
― A
pp
l
y
the most suitable solutions for reducin
g
the noise levels and the acoustic
p
ollution to minimum.
― Carry out the electrical connections professionally and in full compliance with the instructions provided
b
y
the manufacturer and the s
p
ecific re
g
ulations in force.
English
7/75