Performing a Test
104
STAT Tests
STAT tests are a limited number of tests that can be performed in emergency situations, see
page 78. If the meter is configured for performing STAT tests, you are given the chance to per-
form the test when notified of a required quality control test.
1 To perform the measurement without
performing a quality control test, touch
STAT, or:
2 Touch to perform the quality control
test before the measurement.
When a STAT test is performed, this infor-
mation is stored with the result. The
number of permissible STAT tests is
reduced by 1. After all pending quality
control tests are carried out, the specified
number of STAT tests is available again in
case of a new lockout.
Note for international users: Due to limited space on the display some screens may show
“STAT” instead of the localised version of this term.
Pat. Test - Lockout
09:15 am
Test Parameter Locked!
Please Perform QC.
PID111SCHULZM457
SCHULZ, MANFRED
JONES, TOM
Pat:
Op:
proBNPPar:
Min
STAT
PB1234Code:
Pat. Test - Result
09:15 am
620
01/25/2009 10:17
pg/ml
proBNP PB1234
SCHULZ, MANFRED
JONES, TOM
Par:
Op:
Code:
PID111SCHULZM457Pat:
STAT TEST
To Next Page
Loading...
Need help?
General
