Meter Setup
39
Sound
It is possible to activate or deactivate a beep sound for the following circumstances:
If activated, the meter beeps, when
■ it is switched on
■ it detects a test strip
■ pre-heating of the test strip is complete and you need to apply a sample
■ the test is completed and the results are displayed (a long beep)
■ an error occurs (three short beeps)
■ the handheld power supply unit is connected when the meter is on
■ a barcode is scanned successfully (short beep)
■ the barcode scanner is disabled (two short beeps)
■ a scanned barcode is rejected as invalid (three short beeps)
■ a positive test result can be expected, while the measurement still is in progress (a long
beep)
You can also activate a Key Click. When the Key Click is activated, the meter clicks briefly every
time a button is pressed, facilitating the input of information.
Independent from the setting you choose here, the alert information is always shown visually
on screen.
We recommend that you keep the Sound on at all times.
Enabling/disabling the Sound doesn’t affect the measuring performance of the meter.
To Next Page
Loading...
Need help?
General
