298 Rockwell Automation Publication 1769-UM021I-EN-P - May 2018
Chapter 12 Use a Secure Digital Card
.
IMPORTANT We recommend that you leave the SD card installed in the controller and the
card unlocked. The SD card saves extended diagnostic information that you
can send to Rockwell Automation that provides enhanced diagnostics of
your application and firmware revision if circumstances require this data.
This section briefly describes how to use the SD card when installed in a
CompactLogix 5370 controller. The section details how to store a project
from the controller to the SD card and how to load a project from the SD card
to the controller.
However, you can complete other tasks by using the SD card, such as
the following:
• Change the image that is loaded from the card
• Check for a load that was completed
• Clear an image from the memory card
•Store an empty image
• Change load parameters
• Read/write application data to the card
For more detailed information on how to use an SD card, see the Logix5000â„¢
Controllers Nonvolatile Memory Card Programming Manual,
publication 1756-PM017.
To Next Page
Loading...
Need help?
General
