Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 183
Chapter 7
Logic Functions
This section describes the functions of the PowerMonitorâ„¢ 5000 unit. Most
functions require you to configure set-up parameters to align the unit with your
installation and your application requirements. The set-up parameters are listed
by name and described in this section. You can view set-up parameters by using
the PowerMonitor 5000 web page, and when logged in to an Admin account,
changes the setup. Set-up parameters are also accessible by using communication.
See the PowerMonitor 5000 Unit Data Tables
in Appendix A for additional
information on setup parameters including the following:
• Range of valid values
• Default values
•Data type
Set-up parameters can be found in data tables with names beginning with
‘Configuration’, for instance Configuration.Metering.Basic.
Relay and KYZ Outputs
The PowerMonitor 5000 unit is equipped with three electromechanical Form C
relay outputs, typically used for control and annunciation, and one KYZ output
solid-state relay designed for low-power, long-life signaling operation. The typical
use for the KYZ output is to provide a pulse output proportional to energy
consumption to an external totalizer.
Applications
These outputs apply to all models.
Topic Page
Relay and KYZ Outputs 183
Status Inputs 187
Setpoints 191
To Next Page
Loading...
Need help?
General
