Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 447
Appendix D
PowerMonitor 5000 Display Module, Series A
Application Summary
Introduction
The PowerMonitor™ 5000 Display Module, catalog number 1426-DM, is a
PanelView™ Component C400 terminal with factory-installed applications. This
display module displays key information from one, two, or three
PowerMonitor 5000 units. Minimal setup for communication is required.
See the PanelView Component HMI Terminals User Manual, publication
2711C-UM001,
for additional information on performing the steps outlined in
this Appendix.
Terminal Setup
Follow these instructions for configuring the C400 terminal.
1. Obtain an IP address for the C400 terminal and set the address as a static
IP address in the C400 terminal.
2. Open a compatible web browser and type the terminal IP address into the
address bar.
The PanelView Explorer Startup window appears.
3. Disable the web browser pop-up blocker, if necessary.
IMPORTANT In order for the C400 terminal application to communicate with a power
monitor, both need their own unique IP address on the same network and
subnet. The computer that you use for setup must also access the same
network.
To Next Page
Loading...
