Rockwell Automation Allen-Bradley PowerMonitor 5000 Unit - Miscellaneous Commands

218 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 8 Other Functions
Setup
Setup parameters of these functions are in the Configuration.System.General
table on page 293
.
Unit_Error_Action
These are the selections:
0 = Safe mode
1 = Reset (default)
Software_Error_Log_Full_Action
0 = Safe mode
1 = Reset (default)
Miscellaneous Commands
The following commands relate to the operation of the power monitor at a
system level. These commands are found in the Command.System_Registers
table on page 368
.
Command_Word_One
Set this command word value to execute the listed action. These are the
selections:
22 = Restore factory defaults
23 = Reset power monitor system
The semantics for these parameters:
Restore factory defaults = Clears all user-configured values from the
setup menus to their factory default settings.
Reset system = Warm reboot; performs a power-on self-test of the
PowerMonitor 5000 unit.
Related Functions
Configuration lock.