Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 71
Chapter 4
Metering
This section describes the functions of the PowerMonitorâ„¢ 5000 unit. Most
functions require you to configure set-up parameters to align the unit with your
installation and your application requirements. The set-up parameters are listed
by name and described in this section. You can view set-up parameters by using
the PowerMonitor 5000 web page, and when logged in to an Admin account, you
can change the setup. Set-up parameters are also accessible by using
communication.
See the PowerMonitor 5000 Unit Data Tables
, in Appendix A, for additional
information on setup parameters including the following:
• Range of valid values
• Default values
•Data type
Set-up parameters can be found in data tables with names beginning with
‘Configuration’, for instance Configuration.Metering_Basic.
Basic Metering
The PowerMonitor 5000 unit calculates metering results that are based on the
values of a number of set-up parameters. These basic metering parameters are
listed in the table that follows. The basic metering setup is necessary to obtain
accurate, properly scaled metering results.
Basic metering applies to all models of the PowerMonitor 5000 unit.
Topic Page
Basic Metering 71
Wiring Diagnostics 73
Wiring Correction 78
Metering Overview 80
Energy Metering 81
Demand Metering 83
Power Metering 87
Voltage, Current, Frequency Metering 89
Configuration Lock 91
To Next Page
Loading...
Need help?
General
