Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 437
Appendix C
PowerMonitor 5000 Display Module, Series B
Application Summary
Introduction
The PowerMonitor™ 5000 Display Module Series B, catalog number
1426-DM, is a PanelView™ 800 terminal with factory-installed applications.
This display module displays key information from one, two, or three
PowerMonitor 5000 units. Minimal setup for communication is required.
See the PanelView 800 HMI Terminals User Manual, publication
2711R-UM001
, for additional information on the performance of the steps
outlined in this Appendix.
Terminal Setup
To configure the PanelView 800 terminal, follow these instructions. This screen
displays on startup of the PowerMonitor 5000 Display Module.
IMPORTANT For the PanelView 800 terminal application to communicate with a power
monitor, both need their own unique IP address on the same network and
subnet.
TIP You cannot change the Ethernet settings from PanelView Explorer. If you
want to change this setting, you must do so from the terminal configuration
screens.
To Next Page
Loading...
