Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 231
Communication Chapter 9
Number of Elements
These values are the number of elements being read:
1 = Single element write
>1 = Multiple element write, number of elements to read including the
first element
Destination Element
Look up the PCCC address (in Appendix A) of the specific data table address to
read. If performing a multiple element read, the data table addresses the first
element in the array.
RSLogix 5000 Software – CIP Generic Messaging Setup
The following example demonstrates a message instruction to read or write a data
table in the PowerMonitor 5000 unit by using the CIP Generic message type.
This setup applies to ControlLogix and CompactLogix programmable logic
controllers.
Message Type
CIP Generic.
Service Type
These types are the choices:
Get Attribute Single = Read message
Set Attribute Single = Write message
To Next Page
Loading...
