246 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 9 Communication
Input Only
The PowerMonitor 5000 Input Only connection is similar to the Listen Only
connection but does not require an Exclusive Owner connection to exist. The
Input Only connection permits you to configure the power monitor by using the
web interface.
When you first create an Input Only connection, the following module-defined
controller tag is created:
• [ModuleName]:I, the Input tag
The Input tag is mapped to the ScheduledData.Input table. See Appendix A
for
the content of the data table.
To Next Page
Loading...
