Rockwell Automation Publication 1426-UM001J-EN-P - August 2019 67
Setup and Commands Chapter 3
See Appendix A for information on the limits that the data tables specify.
• Fault Action Page - The Fault Action page is used to configure the output
state of the relays if the power monitor experiences a loss of
communication and the unit action when an internal error occurs.
• Metering Configuration Page - The Metering Configuration page is used
to configure the parameters that are related to metering and demand.
ATTENTION: Data limit checks do not confirm values that are appropriate for
the application.
To Next Page
Loading...
