;define1 -100,100,1,none,,none,always,Empty 1D
;define2 -100,100,1,none,,-100,100,1,none,,none,always,Empty 2D
Now the data acquisition is started:
start
;show status
view 10
Note that the command definitions here shall only allow a “quick start” for the use of our delay-line detectors. More advanced
data treatments like defining new (computed) coordinates to the analysis can be done by additionally modifying the DAn Dll
module using a MS C++ compiler of Visual Studio 2011 or above. Please refer to the
manual for details.
Also, there is a “zero-level” of operating for the recent
2011 version, allowing to address the
commands
by a “remote control” scripting language. Again, for details refer to the
manual.
Page 68 of 83 MCP Delay Line Detector Manual (11.0.1304.1)
To Next Page
Loading...